Hutch Assembly

1. Lay 1/2" x 1" floor with 1/2" wires up.

2. Lay ends back and front parallel with floor as shown and clip at 4" intervals around perimeter. Be sure the door lock is toward the floor and under front as it is being clipped to floor.

3. Swing 4 pieces upward as shown and clip at corners.

4. Lay top in place and clip around perimeter at 6" intervals.

Special instructions for assembly when the stack-a-hutch kit used:

4a. Do not clip cages in corners where the stack-a-hutch leg is put into place.

5. Turn cage upside down and lay floor spreader across cage as shown. Fasten at (x) pionts with hog rings or wire. (no spreaders needed for 1A,2A,5A,OR 8A)

How to install the STACK-A-HUTCH kit on the complete cage:

*Each kit should contain 4 legs(A) and 2 tray slides.(B)

1. Slide each leg into the mesh of the wire at the front and rear corners of the cage ends. (Top tabs may be bent around top strand of wire fro a sturdier connection)

2. Install each tray slide by slipping them into the tabs stamped into each leg.

**Bolts are NOT provided, but may be used in multi-stacked units to provide a more permanent structure. This is especially helpful if the stacks are to be moved frequently.

CAGE AND PAN COMBO CAGE

1. Lay 1/2" x 1" floor with wires up.

2. Lay ends back and front paralle with floor as shown and clip at 4" intervals around perimeter. Be sure door lock is toward floor and under front as it is being clipped to floor. (On fronts equipped with swing out door, make sure door swings out away from cage front, not to the inside)

PLEASE NOTE:  Cage sides and back are 2" taller than front. Attach floor 2" up on sides and back only. Also be sure bends on sides turn towards inside of cage to provide support for pan.

3. Swing 4 pieces upward as shown and clip at corners.

4. Lay top in place and clip around perimeter at 6" intervals.

5. Turn cage upright, swing door up and into cage top. Install door hanger.